The depth of this material is 4 mm.
If you want, you can boost the amount of the structure to 6 metres or more. To do this, it’s sufficient to join a two-meter expansion. When selecting a drawing, focus on the space between the arches. This figure must be 65 cm, that’s the most appropriate duration for the specified depth of the material. The width of the doorways according to the producer’s drawing is 90 cm.
Before assembling a polycarbonate greenhouse, then it is necessary to pick a spot because of the place. If this is done correctly, you can provide yourself with a harvest of fresh vegetables for the entire year.
The place for the future greenhouse is marked immediately at the planning of the garden plot. So as to melt the snow at the place of the greenhouse as early as possible, the ideal point on the website is going to be a small elevation. Furthermore, in such a place will not have to worry about large humidity as dirt and atmosphere inside the structure.
Assemble a polycarbonate greenhouse in an elevated gidpostroy.ru site – means to care for the best temperature inside.
If it is not feasible to put a greenhouse on an elevated place, you will need to pour a layer of fine shattered rock about 20 cm and the identical layer of fertile soil to create seedbeds.
Before assembling a greenhouse on your garden plot, it’s also wise to consider where and how this construction is going to be set up. First, you must choose a place for it. The greenhouse should be found in a well-lit area at least a couple meters away from homes, barns and other structures.
How to Put in a greenhouse Based on the sides of the Planet
Make sure you measure the soil surface – it is ideal to remove the surface. This can also get rid of weed seeds. And for simplicity of work, eliminate the soil in a place that is about a meter wider on all sides of the rectangle you want.
Additionally, it is worth thinking about using a base. As manufacturers state, now most greenhouses do not need it, especially if they (greenhouses) are utilized only in the summer and spring period. But, seasoned anglers still recommend earning an elementary basis from a pub. It is extremely simple – it is enough to connect with each other utilizing metal corners and screws four pieces of wood with a cross-section of at least 10 * 10 cm. The size of such a base should be equivalent to the foundation of the future greenhouse.
Simple bar foundation
You might also produce a strip base of concrete. He is more reliable than a pub foundation, but requires greater financial and labor costs. Incidentally, the greenhouse, that is utilised in winter, with no and do not do without it whatsoever.
Stages of the formation of a strip base: a schematic representation
Many manufacturers counsel to put in greenhouse structures without even creating a base. Even for this use, they equip the framework with special T-shaped legs, so that the structure was securely fixed. However, as practice shows, it is still crucial to construct a base: so and the foundation will be more firmly fixed and the components of the basis that are in contact with the ground, will be kept much more in its initial state.
The principal thing is to take care of the material with special agents to protect the wood from moisture. The substance is normally installed on concrete blocks that are dug into the soil. For a six-meter structure, they want 10 bits: four on each side and one at the center of the ends.
Before you do the greenhouse , you will need to select the ideal spot for this. It must be an even website, so the framework was located evenly, without distortions. It needs to be bright and never obscured by trees or buildings.